Figure 4-2: so-dimm socket location – IEI Integration AFL-15i-HM55 v2.00 User Manual
Page 68
Advertising

AFL-HM55 Series Panel PC
Page 57
Figure 4-2: SO-DIMM Socket Location
Step 5:
Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 6:
Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 7:
Install the new DDR memory module by pushing it into the socket at an angle
(Figure 4-3).
Step 8:
Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (Figure 4-3).
Step 9:
Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Advertising
This manual is related to the following products: