2 3.5” disk drive in a 5.25” slot – IEI Integration EC-1040G User Manual
Page 41
EC-1040GB Workstation
Page 31
Step 5:
Insert the appropriate number of retention screws into each side of the 5.25”
disk drive through the drive bracket (Figure 4-7).
Figure 4-7: 5.25” Disk Drive Retention Screws (Other Side Similar)
4.5.6.2 3.5” Disk Drive in a 5.25” Slot
With the use of IEI’s 3.5” to 5.25” drive bay rack, a standard 3.5” disk drive can be installed
into a 5.25” drive bay slot. To install a 3.5” hard disk drive into a 5.25” slot of the drive
bracket, follow the instructions below.
Step 1:
Slide a 3.5” disk drive into a 3.5” to 5.25” drive bay rack. Make sure the
IDE/SATA connector and the power connectors of the drive are facing the rear of
the rack.
Step 2:
Insert the appropriate number of retention screws into each side of the 3.5” disk
drive through the 3.5” to 5.25” drive bay rack (Figure 4-8).