Progressive International Electronics PIcon II Console User Manual
Page 24

PIcon II
Manager
Rev 1.0
January 2014
19
To exit MGR 6, press the <MANAGER> key. MGR 0, the mode entry prompt, will appear
on the display. To return to operator mode, press the <MANAGER> key again.
Manager Mode MGR 7 — Program Operator/Manager PIN Codes
Warning: Care should be observed when using this mode. If the PIN Code is altered, be sure
to make note of the new PIN Code and save in a safe location.
Operator PIN Codes — The display will show the existing Operator PIN Code under
Operator PIN. (The default Operator PIN Code is 1111.) To change the code, enter the
new number (up to 4 digits) on the numeric keypad and press <ENTER>. To proceed to
program Manager PIN Codes, press <ENTER>.
Manager PIN Codes — Under Manager PIN, the existing Manager PIN Code will be
displayed. (The default Manager PIN Code is 2422.) To change the code, enter the new
number (up to 4 digits) on the numeric keypad and press <ENTER> — taking you back
to Operator PIN Codes.
To exit MGR 7, press the <MANAGER> key. MGR 0, the mode entry prompt, will appear
on the display. To return to operator mode, press the <MANAGER> key again.
Manager Mode MGR 8 — Shift Report Setup
The operator Shift Report Setup Mode configures which totals are to be printed on an
operator Shift Report. To choose the totals to be included, simply toggle between Yes and No
by using the <A/B> key. The <SELECT> key cycles to the next option to be programmed.
Totals which may be selected (or declined) for inclusion on the Operator Shift Report are: