Edges (explained in figure 8), Caution – Mammoth V-Cube User Manual

Page 10

Advertising
background image

9. After two sections are assembled, verify that the

assembly is level and square. If an adjustment is re-
quired, make certain to address it immediately, not at
the end of the final assembly.

10. If multi-section unit has more than two sections fol-

low Steps 1 through 9 for each additional section,
always pulling the next section from the first end sec-
tion.

11. Apply a generous bead of Adseal 1800 series clear

silicone based sealant (or equivalent) to the exterior
side frame joint seams to completely cover the sec-
tion split gasket and in such a way that the silicone
bead meets with both frames as in Figure 8. The
bead of clear silicone based sealant should fill the ¼”
gap, as shown in Figure 8.

12. All lifting lugs removed on the exterior of the base

for pulling sections together must be returned or if
not desired the bolts must be set back in place. Once
removed the bolts must be returned and sealed with
clear silicone based sealant for water-tightness. All
other lifting lugs from the unit base may be removed
if desired or left in place. When removing lifting lugs
on the exterior of the base, set the bolts back in
place and seal with clear silicone based sealant for
water-tightness.

Figure 7: Secure the sections pulled together with bolts,
nuts and washers. Do not over tighten.

¼” bead Adseal
1800 clear silicone
based sealant

Figure 8: Apply a continuous bead of Adseal 1800 clear
silicone based sealant (or equivalent) to the exterior side
frame joints and for indoor units along the top frame
joints.

1/8” x 1” neoprene
SOFT SEAL gasket

Bead of Adseal 1800
clear silicone based
sealant

Figure 9: a) Install the gasket strips on the inside edges
of the inside caps; b) Install caps in place with self-drilling
screws; c) Apply a continuous bead of Adseal 1800 clear
silicone based sealant (or equivalent) to the inside cap
seams and partition(s)/divider(s).

CAUTION

Do not over tighten the side bolts as this may cause the
corner posts to warp and break their air- and water-tight
seal.

VCES-V-CUBE-IOM-1A

10

Advertising