Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 374)

344 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
SuperSpan™
12
Displaying SuperSpan information
To display the boundary interface configuration and BPDU statistics, enter the following command.
In this example, the Brocade device has two SuperSpan customer IDs.
Syntax: show superspan [cid num]
The cid num parameter specifies a SuperSpan customer ID. If you do not specify a customer ID,
information for all the customer IDs configured on the Brocade device is shown.
This command shows the following information.
To display general STP information, refer to “Displaying STP information” .
TABLE 55 CLI display of SuperSpan customer ID information
This field... Displays...
CID The SuperSpan customer ID number.
Port The boundary port number.
Customer BPDU Rx The number of BPDUs received from the client spanning tree.
Tunnel BPDU Rx The number of BPDUs received from the SuperSpan tunnel.
Brocade(config)# show super-span
CID 1 Boundary Ports:
Port Customer Tunnel
BPDU Rx BPDU Rx
1/1 1 1
1/2 0 0
Total 1 1
CID 2 Boundary Ports:
Port Customer Tunnel
BPDU Rx BPDU Rx
2/1 0 3
2/2 0 0
Total 0 3