Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 644)

614 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
Creating LAG 3
See
Figure 176 and “Creating LAG-1” for additional information on creating a LAG.
1. Create a LAG as shown below.
Brocade(config)# lag 3 dynamic id 3
Brocade(config-lag-3)#
2. Define the port the LAG will be using.
Brocade(config-lag-3)# ports ethernet 1/3 to 1/4
3. The primary port must be explicitly assigned using the primary-port command.
Brocade(config-lag-3)# primary-port 1/3
4. Deploy a LAG as shown below.
Brocade(config-lag-3)# deploy
5. Assign a name to an individual port within a LAG.
Brocade(config-lag-3)# ICL-to-TOR-A:1/3 ethernet 1/3
Brocade(config-lag-3)# ICL-to-TOR-A:1/4 ethernet 1/4
Creating LAG 4
See
Figure 176 and “Creating LAG-1” for additional information on creating a LAG.
1. Create a LAG as shown below.
Brocade(config)# lag 4 dynamic id 4
Brocade(config-lag-4)#
2. Define the port the LAG will be using.
Brocade(config-lag-4)# ports ethernet 1/5
3. The primary port must be explicitly assigned using the primary-port command.
Brocade(config-lag-4)# primary-port 1/5
4. Deploy a LAG as shown below.
Brocade(config-lag-4)# deploy
5. Assign a name to an individual port within a LAG.
Brocade(config-lag-3)# lag-client-1:1/2 ethernet 1/5