Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 13)

Brocade Mobility 7131N-FGR Access Point Installation Guide 5
53-1001948-01
Chapter
2
Hardware Installation
Brocade Mobility 7131N-FGR Access Point installation includes mounting the
access point, connecting the access point to the network, connecting antennae and
applying power. Installation procedures vary for different environments.
The Brocade Mobility 7131N-FGR Access Point has the following port designations:
• GE1/POE - LAN port
• GE2 - WAN Port
Precautions
Before installing the Brocade Mobility 7131N-FGR Access Point, verify the following:
• Do not install in wet or dusty areas without additional protection. Contact a
Brocade representative for more information.
• Verify the environment has a continuous temperature range between -20° C to
50° C.
Requirements
The minimum installation requirements for a single-cell, peer-to-peer network:
• A Brocade Mobility 7131N-FGR Access Point (in either of its two available
dual-radio models)
• 48 Volt Power Supply (50-14000-247R)
• A power outlet
• Dual-band antennae or an antenna specifically supporting the AP’s 2.4 or 5
GHz band
AP7131N_InstallationGuide.book Page 5 Tuesday, August 24, 2010 5:09 AM