Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 16)

Mounting the access point
2
8 Brocade Mobility 7131N-FGR Access Point Installation Guide
53-1001948-01
Radio 1 or Radio 2 antennae depending on which radio is selected for the scan.
Certain Rogue AP detection features use a radio to perform dual-band scanning. The
dedicated radio should be connected to an appropriate dual-band dipole antenna
(Part No. ML-2452-APA2-01)
R1 defines the access point’s radio 1 antenna connectors and R2 defines radio 2
antenna connectors.
Mounting the access point
The Brocade Mobility 7131N-FGR Access Point can attach to a wall, mount under a
suspended T-Bar or above a ceiling (plenum or attic) following the same installation
instructions. Choose one of the following mounting options based on the physical
environment of the coverage area. Do not mount the access point in a location that
has not been approved in a site survey.
Wall mounting
Wall mounting requires hanging the access point along its width (or length) using
the pair of slots on the bottom of the unit and the access point mounting template
(on the next page) for the screws.
AP7131N_InstallationGuide.book Page 8 Tuesday, August 24, 2010 5:09 AM