Brocade Virtual ADX Installation and Deployment Guide (Supporting ADX v03.1.00) - Manual (Page 73)

Server Load Balancing in One-arm topology with VLAN tagging
Deploying SLB in One-arm topology with VLAN tagging
The example below shows the use of VLAN tagging on the Brocade Virtual ADX to support two or more
VLANs using just one data port on the Brocade Virtual ADX. The data port eth1 is a tagged member of
two VLANs 100 and 200. The port group to which eth1 is connected is configured to be in VLAN 4095.
Using VLAN tagging on eth1 eliminates the need to use other data ports on the Brocade Virtual ADX.
The vSwitch must be configured to be in the non-promiscuous mode.
FIGURE 25 Deploying SLB in One-arm topology with VLAN tagging
Configuring SLB in One-arm topology with VLAN tagging
Virtual ADX#config term
Virtual ADX(config)#vlan 100
Virtual ADX(config-vlan-100)#tag eth1
added tagged port ethe 1 to port-vlan 100.
Virtual ADX(config-vlan-100)#router-interface ve 1
Virtual ADX(config-vlan-100)#int ve 1
Virtual ADX(config-vif-1)#ip address 192.168.1.9 255.255.255.0
Virtual ADX(config-vif-1)#exit
Virtual ADX(config)#vlan 200
Virtual ADX(config-vlan-200)#tag eth 1
added tagged port ethe 1 to port-vlan 200.
Virtual ADX(config-vlan-200)#router-interface ve 2
Virtual ADX(config-vlan-200)#int ve 2
Virtual ADX(config-vif-2)#ip address 192.167.1.9 255.255.255.0
Server Load Balancing in One-arm topology with VLAN tagging
Brocade Virtual ADX Installation and Deployment Guide 73
53-1003241-01