KROHNE OPTIWAVE 6300C EN - Manual (Page 27)

INSTALLATION
3
27
OPTIWAVE 6300 C
www.krohne.com 03/2014 - 4000547004 - HB OPTIWAVE 6300 R04 en
• If you attach more or less extensions than were initially ordered, change the antenna
extension value in Supervisor Supervisor Supervisor Supervisor mode. Go to Supervisor > Advanced setup > Installation > Supervisor > Advanced setup > Installation > Supervisor > Advanced setup > Installation > Supervisor > Advanced setup > Installation >
Antenna Extension Antenna Extension Antenna Extension Antenna Extension.
i Use the display screen or HART
®
communication (PACTware™). Antenna extension =
antenna extension length × number of extensions.
• If you changed the antenna extension value in Supervisor Supervisor Supervisor Supervisor mode, also change the blocking
distance value. Go to Supervisor > Advanced setup > Installation > Blocking Distance Supervisor > Advanced setup > Installation > Blocking Distance Supervisor > Advanced setup > Installation > Blocking Distance Supervisor > Advanced setup > Installation > Blocking Distance.
i Use the display screen or HART
®
communication (PACTware™). Minimum blocking
distance = antenna length + (antenna extension length × number of extensions) + 0.3 m /
12¨.
3.7.4 How to turn or remove the signal converter
INFORMATION!
The converter turns 360
° . The converter can be removed from the process connection assembly
under process conditions.
Figure 3-14: How to turn or remove the signal converter
1 Tool: 5 mm Allen wrench (not supplied)
2 Cover for the wave guide hole on top of the process connection assembly (not supplied)
CAUTION!
If you remove the converter, put a cover on the wave guide hole on top of the process connection
assembly.
When the converter is attached to the process connection assembly, tighten the lock screw.