KYORITSU 4202 - Manual (Page 16)

̶ 14 ̶
8-5 Memory function
This function is to save and display the measurement results.
Saving the measurement results
(1) Select any data number (from 1 to 100) by using the Cursor button
or at ACA or Earth resistance function, and save the measurement
results.
◇ When the Cursor button is being pressed down, the number switches
quickly.
(2) To save the measurement result being displayed on the LCD, press the
Save button . Then the result is saved to the selected data number.
(" MEM " is displayed for about 1 second.)
◇ After saving the data, data number automatically switches to the next
available data number (present data number +1) and the next measured
value can be saved to it.
(The data number returns to 1 after the measurement result is saved to
the data number 100.)
◇ When the new measurement result is saved to the data number on
which the previous measurement result is saved, previous data will be
overwritten.
◇ When saving a data while the data hold function is activated, the
readings which is being held on the LCD will be saved.
Recalling the measurement results in memory
To activate the memory function, press the Memory mode button .
Then " MEM " is displayed on the LCD.
Pressing the Cursor button or changes the data number displayed
on the LCD, and the measurement result in memory is displayed accordingly.
◇ To disable the memory mode, press the Memory mode button again or
press the Function button . (Then " MEM " symbol disappears.)
◇ Bars " " are displayed for the Data number that does not contain
any test result.
Clearing the measurement results in memory
To clear the measurement result, press the Save button with the Memory
mode button pressed down. The message " " is displayed on the
LCD for about 2 seconds and the measurement result on the selected data
number is cleared.
(Then the indication on the LCD becomes " ".)
◇ Follow the procedure below to delete the all measurement results.
(1) Press the Power button , while the instrument is off, while the
Memory mode button and the Save button are being pressed down.
Then release the Power button only.
(2) Instrument is turned on; " MEM ", " " and " " are displayed
on the LCD for about 2 sec..
Now all the stored data are deleted.