Pyromation Series 610 1_16 DIN - Manual (Page 14)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
How to use this manual
This manual is structured to give easy access to the information required for all aspects of
the installation and use and of the products:
Section 1: Introduction - A brief description of the product range.
Section 2: Installation - Unpacking, installing and panel mounting instructions.
Section 3: Plug-in Options - Installation of the plug-in option modules.
Section 4: Wiring Guidelines - Guidance on good wiring practice, noise avoidance, wiring
diagrams and input/output connections.
Section 5: Powering Up - Powering up procedure and descriptions of displays & switches.
Section 6: Messages & Error Indications - Display Messages and fault indications.
Section 7: Operation Modes - Describes operating modes common across the range.
These include Select Mode for gaining access to the Setup and Configuration menus,
Automatic tuning on controllers and the Product information menus.
Section 8: P6100, P6120, P8100 & P4100 Model Group - Describes unique operating
features of these process controllers. It covers the Configuration, Setup & Operator menus,
Communications parameters, adjusting Setpoint, use of Manual Control and PID auto-tuning.
Section 9: P6170, P8170 & P4170 Model Group - Describes unique operating features of
these valve motor controllers. It covers the Configuration, Setup & Operator menus,
Communications parameters, adjusting Setpoint, use of Manual Control and PID auto-tuning.
Section 10: P6700, P8700 & P4700 Model Group - Describes unique operating features of
these limit controllers. It covers the Configuration, Setup & Operator menus, Communications
parameters, adjusting the Limit Setpoint and resetting the Limit Output.
Section 11: P6010 & P8010 Model Group - Describes unique operating features of these
indicators. It covers the Configuration, Setup & Operator menus, Communications
parameters, using the Tare and Multi-Point Scaling Functions.
Section 12: Manually Tuning Controllers - Advice on manually adjusting the Process and
Valve Controllers tuning parameters.
Section 13: Modbus Serial Communications - Details the physical layer and message
formats used for the Modbus communications protocol common to all products in the range.
Section 14: ASCII Serial Communications - Details the physical layer and message
formats used for the ASCII serial communications protocol available on some products.
Section 15: Calibration Mode - Step-by-step instructions to calibrate the instrument. This
section is intended for use by suitably qualified personnel.
Appendix 1: Glossary - Explanations of the terms used and product features.
Appendix 2: Specification - Technical specifications for all products in the range.
Appendix 3: Product Coding - Product model/ordering codes.
59305, Issue 6 – March 2006
Page 9