Crystal nVision Lab Reference - Manual

MA20 Module Instructions
—
REQUIREMENTS
The MA20 requires these items to work with the nVision Chassis and CrystalControl:
•
CrystalControl 1.2 or later
•
nVision Chassis fi rmware R080005 or later
•
Switch Test Setup
Note: Conduct the Switch Test Setup every time you use the MA20 with a new nVision chassis.
—
INSTALLATION
 Install the MA20 module.
1 Disconnect the nVision USB cable.
2
Remove the 4AA battery module.
3 Insert your MA20 into your nVision Chassis in the desired bay and fasten it in place with the included screws.
4 Reinstall the 4AA battery module and turn on your nVision with the (Power) button.
5
Reconnect the nVision USB cable to the nVision chassis and then to your PC.