Dwyer 32DZ - Manual (Page 4)

949-1318 Page 4 of 40 June, 2000
From the front of the panel, slide the housing through the cutout. The
housing gasket should be flat against the housing flange before
installing.
From the rear of the panel slide the mounting collar over the housing.
Hold the housing with one hand and using the other hand, push the
collar evenly against the panel until the spring loops are slightly
compressed. The ratchets will hold the mounting collar and housing
in place. To remove, gently lift the ratchets and slide a piece of
heavy paper or mylar sheet under each ratchet (a business card
works well). Slide the collar off of the housing.
45 + 0.6
(1.772 + 0.02)
22.2 + 0.3
(0.874 + 0.012)
20.5
(0.807)
25.4
(1.00)
Prepare the panel by cutting and deburring the required opening(s).
Collar
Panel
Gasket