Milestone Paxton Integration Component - Manual (Page 9)

XProtect Paxton Integration Plug-in User's Guide
www.milestonesys.com Page 9 Configuration
Configuration
This chapter provides detailed guidance in the configuration of the Milestone Paxton Integration Component with
some additional basic guidance regarding the configuration of the Paxton Net2 and the XProtect servers.
However, it is still recommended to obtain a detailed knowhow about the configuration of these products before
proceeding.
The chapter is divided into the following sections:
1) Initial configuration steps common to all XProtect servers. A guide on how to prepare the Net2 server for
this integration and how to establish the connection from the XProtect server to the Net2 server.
2) Configuration steps specific to XProtect Enterprise, Professional, Express and NVR
3) Configuration steps specific to XProtect Corporate
Initial configuration steps
These initial steps are common to all XProtect servers:
1. Setting up the connection between XProtect and Net2
2. Define mappings between doors and cameras
3. Mapping of Net2 events to XProtect alarms
To perform these steps on the XProtect Enterprise, Professional, Express and NVR, you need to start the
Management Application on the server computer. On XProtect Corporate, you need to start the Management
Client and connect to the target server.
Setting up the connection between XProtect and Net2
The first step is to connect XProtect to Net2.
Before starting the configuration of the XProtect server, the “OEM Client” user account needs to be activated and
configured on the Net2 server. On the Net2 Access Control application double-
click the “OEM Client” account to
set the password:
Figure 3: Set OEM Client password