Specify authentication information pane – HP StorageWorks XP10000 Disk Array User Manual
Page 129
Figure 74 Specify Authentication Information pane
Specify the following user information for the port or iSCSI target selected in the Port tree:
• Target Name: Selected port's iSCSI name. You cannot change the iSCSI name.
• User Name: iSCSI target's user name up to 128 characters. You can use alphanumeric
characters, spaces, and the following symbols in a user name:
. - + @ _ = : / [ ] , ~
User names are case-sensitive. For example, port1 and Port1 represent different user names.
• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32
characters. You can use the same characters and symbols as a user name.
• Re-enter Secret: Specify the secret again for confirmation.
4.
Click OK. The specified user information for the port appears in blue in the Authentication
information (Target) list.
5.
Click Apply. A confirmation message appears.
6.
Click OK. Settings are applied to the array.
Clearing an iSCSI target's user information (when performing mutual
authentication)
1.
Start LUN Manager, and display the Authentication pane (
).
2.
In the Port tree, expand the iSCSI folder, and select the port or iSCSI target whose user information
you want to clear. The currently registered user information for the port or iSCSI target appears in the
Authentication Information (Target) list on the right of the tree.
3.
Right-click any point in the Authentication information (Target) list, and select Clear Authentication
Information. The Clear Authentication Information pane appears.
4.
Click OK. The selected iSCSI target's user information disappears from the Authentication information
(Target) list.
5.
Click Apply. A confirmation message appears.
6.
Click OK. Settings are applied to the array.
Settings and connection results in authentication of hosts (iSCSI environments)
During authentication of hosts, the connection result is determined based on the combination of the
following iSCSI target settings:
•
iSCSI target's setting in the Port tree: enable ( ) or disable ( )
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
129