HP XP Continuous Access Software - Manual (Page 229)

Table 45 Error Codes and Error Contents When Operating RAID Manager (continued)
Error Contents Error Code
(SSB2)
Error Code
(SSB1)
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified journal group
was unregistered. E87B
Journal volume is not registered in the specified journal group. E87C
A request of XP Continuous Access Journal Pairresync was received.
However, the command was rejected because the specified volume was
not for the XP Continuous Access Journal pair. E87D
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified P-VOL or
S-VOL was a journal volume. E87E
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the emulation type was
different between the specified P-VOL or S-VOL and the journal volume. E880
XP Continuous Access Journal pair cannot be created or resynchronized
because of the power-on processing. E881
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the emulation type of the
specified master journal group or the restore journal group was invalid. E882
The specified mirror ID number or the CTG number differs from the
registered mirror ID number or the CTG number. E883
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified master journal
group was already used for a pair with another restore journal group. E888
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified journal group
was already used in another XP Continuous Access Journal’s mirror ID. E889
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified volume was
already registered on the journal group. E890
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the number of pairs that E891
are registered in the specified master journal group or restore journal
group already reached the maximum number.
When creating a pair using journal group in the configuration where
three XP Continuous Access Journal sites were combined, a request of E894
pair creation of the third mirror was received in the same journal group,
so the command was rejected.
A request of Paircreate was received. However, the command was rejected
because of the one of following reasons. E897
• The specified primary journal group and the secondary jorunal group
do not permit the configuration combining three XP Continuous Access
Journal sites.
•
The specified secondary journal group is already used as a secondary
journal group of another mirror.
•
The paired journal group of the specified mirror is already used by
another mirror.
When creating a pair using journal group that does not permit the
configuration combining three XP Continuous Access Journal sites, because E898
a paircreate request of the second mirror was received in the same journal
group, the command was rejected.
Troubleshooting When Using RAID Manager 229