HP Virtual Connect Enterprise Manager Software - Manual (Page 59)

Table 22 Parameter descriptions for -set iscsi-boot-param (continued)
Optional Required Description Parameter
x
NOTE: The
-targetport2 parameter
is required if the
-targetip2
parameter is
specified.
Specifies the TCP port
associated with the
alternative target IP address.
The default value is 3260. -targetport2
x Specifies the authentication
method. The initiator and -authentication
target must agree on an
authentication method or the
iSCSI initiator cannot log on
to the target. Supported
authentication values include
none
, chap, and chapm.
The default selection for this
attribute is none.
x
NOTE: The -username
parameter is required if the
authentication type is chap
or chapm.
Specifies the user name for
authentication. The
user-name length is a
maximum of 223 characters.
If the name string contains
non-alphanumeric -username
characters, it should be
enclosed in quotation marks.
x
NOTE: The -secret
parameter is required if the
authentication type is chap
or chapm.
Specifies the secret
password for chap
authentication. It is specified
as a string or a long hex
value (starting with 0x). This
value must be at least 96 -secret
bits (12 bytes, 24
hexadecimal digits) and at
most 16 bytes, 32
hexadecimal digits long.
x
NOTE: The
-mutualusername
parameter is required if the
authentication type is
chapm
.
Specifies the user name for
authentication. The
user-name length is a
maximum of 223 characters.
If the name string contains
non-alphanumeric
characters, it should be
enclosed in quotation marks. -mutualusername
x
NOTE: The
-mutualsecret parameter
is required if the
authentication type is
chapm
.
Specifies the password for
authentication. It should be
specified as a string or a
long hexadecimal value
(starting with 0x). This value
must be at least 96 bits (12
bytes, 24 hexadecimal -mutualsecret
digits) and at most 16 bytes,
32 hexadecimal digits long.
x Allows the iSCSI option
ROM to retrieve the iSCSI -iscsibootparamdhcp
boot parameters from DHCP
or through static
configuration. Valid values
are enabled and
disabled
. The default
set iscsi-boot-param 59