HP Insight Management-Software - Manual (Page 47)

Table 17 Parameter descriptions for -set fcoe-connection (continued)
Optional Required Description Parameter
The default port speed is
preferred.
IMPORTANT: The speed
type Auto does not apply to
fabrics and 1 Gb to 8 Gb
does not apply to FCoE
networks.
x
IMPORTANT: The
-customspeed parameter
is required if the speed type
is custom.
Specifies the user-defined
speed for the server port.
Valid values include 100
Mb to 10 Gb configured in
100 Mb increments. The
acceptable value is 100
Mb/s to 10,000 Mb/s. -customspeed
x Controls whether the FC
HBA port is enabled for -bootpriority
SAN boot and affects the
BIOS boot order. Valid
values include the following:
•
usebios
•
primary
•
secondary
•
disabled
Only one boot parameter is
allowed per FCoE
connection.
x
IMPORTANT: The
-bootport parameter is
required only when the
bootpriority
parameter
is set to either primary or
secondary
.
Specifies the target World
Wide Port Name (WWPN)
of the controller interface on
the Fibre Channel storage
target. The port name is a
64-bit identifier in the
following format:
NN:NN:NN:NN:NN:NN:NN:NN
-bootport
The designation N stands for
a hexadecimal number.
x
IMPORTANT: The
-bootlun parameter is
required only when the
bootpriority
parameter
is set to either primary or
secondary
.
Specifies the logical unit
number (LUN) of the volume
used for SAN boot. Valid
values include an integer
from 0 to 255 or 16
hexadecimal digits (HP-UX
only). -bootlun
Output
The function returns the result of the set operation or a jobid if –nb is specified.
set fcoe-connection 47