HP Surestore 64 Director Switch - Manual (Page 129)

Configure Operating Parameters 113
Config
uring the
Di
re
ctor
over the new, shorter path may arrive ahead of older frames still in route over the older
path.
If rerouting delay is enabled, traffic ceases in the fabric for the time specified in the
E_D_TOV field of the dialog box. This delay allows frames sent on the old path to exit
to their destination before new frames begin traversing the new path.
The operating parameters are stored in NV-RAM on the switch.
Procedure
To configure Fibre Channel operating parameters for the director, use the following steps:
1. Configure the director offline.
C AUTION Setting the director offline terminates all Fibre Channel connections.
a. Select Set Online State from the Maintenance menu.
The Set Online State dialog box displays as shown in <X-Ref>Figure 38.
Figure 38 Set Online State Dialog Box (Currently Offline)
b. Click the Set Offline button to set the director offline as shown in <X-Ref>Figure 38.
2. Select Operating Parameters from the Configure menu
The Configure Operating Parameters dialog box displays.