HP XP Continuous Access Software - Manual (Page 120)

Table 27 Journal Operation Window Details (continued)
Description Item
Halt: An operation for splitting or deleting the mirror is
in progress. The primary data volume and the secondary
data volume are not synchronized.
Stopping: An operation for splitting or deleting the mirror
is in progress. The primary data volume and the secondary
data volume are not synchronized.
In the 3DC cascading configuration that consists of three
Continuous Access Journal sites, the status might remain
Stopping to maintain the journal data for perfoming the
delta resync operation when the pair status is Suspending
between the primary site and the intermediate site by
failure. For details on disaster recovery of this case, see
Recovering from a Failure by Duplicating Volumes in a
3DC Cascading Configuration.
Stop: An operation for splitting or deleting the mirror is
finished. The primary data volume and the secondary data
volume are not synchronized.
Hold: an XP Continuous Access Journal pair for the delta
resync operation is created.
Holding: an XP Continuous Access Journal pair for delta
resync operation is being created.
Hold(Failure): An error occurred with the XP Continuous
Access Journal pair for the delta resync operation.
Blank: No data volumes are registered in this journal
group.
• Mirror ID: Identifies the mirror. This column is blank if
the attribute of the journal group is neither Master nor
Restore.
•
S/N (LDKC): The serial number of the remote storage
system. The LDKC number is enclosed in the parentheses
following the serial number. This column is blank if the
attribute of the journal group is neither Master nor
Restore.
•
Pair JNLG: The number of a journal group in the remote
storage system. This column is blank if the attribute of
the journal group is neither Master nor Restore.
120 Using the XP Continuous Access Journal GUI