HP LaserJet M9059 Multifunction Printer series - Manual (Page 41)

Menu item Sub-menu item Sub-menu item Values and Description
IPV4 Settings Config Method Specifies the method by which TCP/IPv4 parameters
for the HP Jetdirect print server will be configured.
Bootp : Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
DHCP (Default): Use DHCP (Dynamic Host
Configuration Protocol) for automatic configuration
from a DHCPv4 server. If selected and a DHCP lease
exists,
DHCP Release and DHCP Renew menus are
available to set DHCP lease options.
Auto IP : Use automatic link-local IPv4 addressing. An
address in the form 169.254.x.x is assigned
automatically.
Manual : Use the Manual Settings menu to configure
TCP/IPv4 parameters.
DHCP Release This menu appears if Config Method was set to
DHCP and a DHCP lease for the print server exists.
No (default): The current DHCP lease is saved.
Yes : Release the current IP address. Note that the
printer will lose network connectivity until it reboots at
which point it may have a new address.
DHCP Renew This menu appears if Config Method was set to
DHCP and a DHCP lease for the print server exists.
No (default): The print server does not request to renew
the DHCP lease.
Yes : The print server renews the lease on it's IP
address.
Manual Settings (Available only if Config Method is set to Manual )
Configure parameters directly from the printer control
panel:
IP Address : The unique IP address of the printer
(n.n.n.n), where n is a value from 0 to 255.
Subnet Mask : The subnet mask for the printer
(m.m.m.m), where m is a value from 0 to 255.
Syslog Server : The IP address of the syslog server
used to receive and log syslog messages.
Default Gateway : The IP address of the gateway or
router used for communications with other networks.
Idle Timeout : The time period, in seconds, after which
an idle TCP print data connection is closed (default is
270 seconds, 0 disables the timeout).
Table 2-10 Jetdirect menus (continued)
ENWW Use the Administration menu 27