MBRP S6206 - Manual (Page 4)

5. Install the Muffler over the Extension Pipe. The
Hanger Clamp is used at the connection between
the Muffler and the Extension Pipe and installed
into the OEM rubber hanger at this position. Install
the “T” Hanger Clamp into the two OEM rubber
hangers located above the outlet of the Muffler.
See Figure 8.
Figure 8
6. Install the Tail Pipe from the rear of the truck, over the axle and attach
to the Muffler Outlet. Install the tail pipe hanger into the OEM hanger,
then adjust for best axle clearance and Tail Pipe exit location to
complete. See Figure 9.
7. Install the provided clamps around the pipes where needed. Adjust the
Tail Pipe and check along the whole length of the exhaust system to
ensure that there is adequate clearance around the fuel and brake lines
or any wiring. If any interference is detected relocate or adjust.
Figure 9
8. Make sure the exhaust is in place before tightening the clamps. Start at the front of the exhaust system
and begin tightening all connections.
9. Install and adjust Tip to suit. Using a 17mm wrench tighten lock bolt located on Tip. A Tips is not
included with “INSTALLER” or “XP SERIES” kits. A Tip may be purchased separately, check with
your dealer.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of
your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
S6206 © 12/05 Page 4 of 4