AEG KO-LAVAMAT 74335 - Manual (Page 30)

Operating Instructions
30
The washing machine
vibrates during opera-
tion or is unstable.
The transport packaging has
not been removed.
Remove transport packaging
according to the installation
and connection instructions.
The height-adjustable screw
feet are wrongly positioned.
Adjust the feet according to
installation and connection
instructions.
There is very little washing in
the drum (e.g. only one
dressing gown).
This does not impair the
function.
The water could not be com-
pletely pumped out before
spinning because
the drain hose is kinked or
the drain pump is blocked.
Check the drain hose and re-
move any kinks if necessary,
or clean the drain pump and,
if required, remove foreign
bodies from the pump hous-
ing.
Excessive foaming dur-
ing the main wash. Probably too much detergent
was used.
It may be necessary to re-
duce the amount of deter-
gent used. Follow the
detergent manufacturer's
recommendations.
Water runs out from
under the washing ma-
chine.
The screw connection on the
inlet hose is leaking. Tighten the inlet hose screw
connection.
The drainage hose is leaking.
Check the drainage hose and
replace it if necessary.
The drain pump cover is not
correctly closed.
Close cover correctly.
Washing is caught in the
door.
Stop the programme, remove
washing from the door, start
a new programme.
The emergency drain hose is
not correctly sealed or is
leaking.
Seal the emergency drain
hose correctly (see section
“Carrying out an emergency
emptying“). Call your local
AEG Service Force Centre if
the emergency drain hose
leaks.
Problem Possible Cause Solution