Videotec ULISSE COMPACT THERMAL - Manual (Page 47)

EN - English - I
nstruc
tions manual
45
10.7 Recalling the Home
position
Using the control keyboard it is possible to recall
a previously saved Home position (Scan No. 1)
(for further information, refer to the manual of the
keyboard in use).
10.8 Enabling the Wiper (Wiper)
h Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
To enable/disable the Wiper refer to the manual of
the keyboard or to Tab. 14, page 47).
j If it is left on, the Wiper automatically
disables itself.
10.9 Enabling the Washer
(Washer)
h Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
To enable/disable the Washer refer to the manual of
the keyboard or to Tab. 14, page 47).
To configure the Washer, refer to "9.6.7 Washer Menu",
page 38.
10.10 Reboot the device
By means of the control keyboard it is possible to
send the device resetting command (for further
information, refer to the manual of the keyboard in
use or to Tab. 14, page 47).
10.11 Switching of the
secondary video output
To select the video signal (of the integrated module
or of the thermal camera), please refer to controls
Video 2 - integrated module and Video 2 - thermal
camera (Tab. 14, page 47).
10.5 Enabling Autopan Function
Using the control keyboard it is possible to enable the
Autopan (for further information, refer to the manual
of the keyboard in use or to Tab. 14, page 47.
Disabling can be carried out by moving the joystick
or by recalling a different type of movement.
To configure the Patrol function, refer to "9.6.4.7
Autopan Menu", page 36.
10.6 Recalling a pattern (Tour)
The Tour functioning mode allows the repetition of a
previously recorded route in a continuous manner.
The pan & tilt can store up to 3 Tours, each lasting no
more than 2 minutes.
To save a Tour, enter the special preset of the number
of Tour to be saved using the keyboard (Tab. 14,
page 47).
To simplify the recording of the Tour, the pan &
tilt automatically limits the speed of the Pan & Tilt
depending on the Zoom factor.
While the Tour is being recorded, the remaining
recording time is displayed, as shown in the figure.
ID: 1
------------------------
RECORDING TOUR MODE
Iris to stop 99%
------------------------
Pan : - 5.56
Tilt: +120.01
Zoom: 36.00x
Fig. 96
To interrupt recording, press the Iris Open or Iris Close
key.
To start the play-back of a Tour, enter the special
preset of the number of Tour to be displayed using
the keyboard (Tab. 14, page 47).