Pro-Lite PL-XPSB4014 (shown) - Manual (Page 39)

32
HELP SECTION - SOFTWARE
Can I assign an IP address to the Pro-Lite sign?
This can only be done with a partnering device such as a LAN serial server. You
can purchase one directly from Pro-Lite. Ask for the Mini-Web!
How do I display the current Count Variables in my message
1. Go to the part of your message where you want the Current Count
Variable to be displayed.
2. Click on Commands on the menu bar, then click on Target.
3. Click on the Current Count Variable you wish to use.
If you used the Set Target to "count up" to a target, you can only select to use
the variables labeled with (Count Up).
If you used the Set Target to "count down" to a target. you can only select to
use the variables labeled with (Count Down).
How do I run multiple Pages using the "Link Page" command.
PLEASE NOTE: If your Pages have already been sent to the sign, you cannot
automatically run multiple pages. Use the example format given below to run
multiple pages. Example: we want Pages A, B, and C to run as one message,
1. Open an existing file or begin to type your message for Page A.
2. Place the cursor at the end of the message.
3. Insert the "Link Page" command. To insert the "Link Page" command
in your message, click on "Commands" on the menu bar, then click on
"Special", and "Link Page".
4. Now enter the letter of the Page you wish to run after Page A is done.
The Page letter must be in upper-case.
5. Using our example, your message should look similar to the following:
THIS IS YOUR MESSAGE FOR PAGE A. <Link Page>B
6. Now send your message to Page A.
7. Following steps 1 -5, do the same for Page B.
THIS IS YOUR MESSAGE FOR PAGE B.<Link Page>C
8. Now send your message to Page B.
9. Following steps 1 -5, do the same for Page C.
THIS IS YOUR MESSAGE FOR PAGE C.<Link Page>A
10. Send your message to Page C.
11. Now run Page A. To run Page A, go to “Functions” and “Run Page”.
Enter your Sign ID Number and select “Page Number = A”. Now click
on “OK”
As you can see from our example, each Page is linked to another Page using
the “Link Page” command.
?