Allied Telesis AT-GS950/48 - Manual (Page 124)

Chapter 10: MAC Address Table
124
Static Unicast MAC Address Configuration
This procedure explains how to set the static multicast feature for each
port on the AT-GS950/48 switch. Before beginning this procedure, you
must create either an 802.1Q VLAN ID or a Port-Based VLAN Index. For
information about defining these parameters, see:
 “Tagged VLAN Configuration” on page 155 regarding the 802.1Q
VLAN ID parameter.
 “Port-Based VLAN Configuration” on page 162 regarding the Port-
Based VLAN Index parameter.
To add a static MAC address to the switch, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
The Bridge folder expands.
2. From the Bridge folder, select Static Unicast.The Static Unicast
Address Table Page is displayed. See Figure 38 for a partial view of
this page.
Figure 38. AT-GS950/48 Static Unicast Address Table Page
3. Select either the 802.1Q VLAN ID or Port-Based VLAN Index radio
button and enter the respective VLAN ID (1-4000) or VLAN Index (1 -
52).