Hubbardton Forge 138901 - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved.
30867
Assembly & Installation Instructions
Complete Assembly & Install Fixture (Figures 2-5)
Component Parts
A Support Cable
B Crossbar H Large Diameter (Canopy) Pipe
C Cable Gripper I Plastic Sleeve
F Canopy J Clutch
G Canopy Ring K Small Diameter (Fixture) Pipe
1. Place canopy (F) over canopy pipe (H), followed by canopy
ring (G). Make sure smaller diameter side of canopy ring is
oriented up toward the canopy.
2. Thread wires and support cable (A) from the fixture pipe (K)
through the canopy pipe (H).
3. Unscrew the clutch (J) from the canopy pipe (H); slide it
across the wires and onto the fixture pipe (K). Follow
this with the plastic clutch sleeve (I), oriented so the tapered
end of the clutch sleeve nests in the clutch. (Figure 2).
4. Slide the canopy pipe (H) as far as necessary to give
you the total length of the fixture which you desire.
Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy pipe (H). There must be
a minimum 1-1/2" of inner pipe inside the outer pipe. Hand-
tighten the clutch to temporarily hold this adjustment. The
clutch is not securely fastened at this point; do not depend
on it to hold the fixture. Important: To ensure full connection
strength, be sure the tapered end of the plastic clutch sleeve
(I) is oriented toward the clutch (J) when assembled and
securely tighten set screw (Figure 3).
5. Carefully slide canopy ring (G) and canopy (F) down over
fixture pipe (K) until they rest on the fixture.
6. Insert support cable (A) into cable gripper (C) and push until
cable is tight and has no slack. Once support cable is at the
correct height, excess cable behind the gripper can be cut
off (Figure 4, next page).
7. Using two machine screws (not provided), fasten the cross
bar (B) to the electric box.
A367
Finn Adjustable Pendant 138901 Page 2 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Continued)
A
B
C
F
G
H
I
J
K
LARGE DIAMETER PIPE
TAPERED END OF
PLASTIC SLEEVE
(Figure 2)
(Figure 3)