Sony MZ-RH1 - Manual (Page 22)

When you unplug the USB cable from the computer
Be sure to remove the recorder as follows. If not, damage to the data may occur.
1 Make sure that the operation lamp on the recorder is not flashing rapidly.
2 Press
 · CANCEL on the recorder.
Make sure that the operation lamp on the recorder is off.
“EJECT DISC OK” appears in the display.
Depending on the conditions, it may take some time until “EJECT DISC OK” appears in the
display.
3 Unplug the USB cable from the computer.
When you remove the disc from the recorder
1 Follow steps 1 and 2 of “When you unplug the USB cable from the computer” above.
2 Remove the disc from the recorder.

This recorder supports Hi-Speed USB*.
* Compatible with USB 2.0 Specification.
Notes
• Make sure not to connect the USB cable while the recorder is operating. This may cause the recorder to
malfunction or noise to be output.
• Depending on the connection, it may take some time before the recorder is recognized by the computer. If you
operate the recorder or the computer before the recorder is recognized, “RECONNECT USB” appears in the
display. If this happens, reconnect the USB cable.
• If the operation lamp flashes rapidly, do not disconnect the USB cable. This may cause the recorder to
malfunction or the destruction of audio data.
• If you use the recorder connected to the computer, it is recommended that you insert a fully charged
rechargeable battery as a precaution against power failures, disconnection of the USB cable or other unforeseen
occurrences. We do not assure the results should there be a mis-operation, transfer failures, or destruction of
audio data caused by unforeseen occurrences.
• If you disconnect the USB cable from the recorder and want to reconnect it, make sure to wait at least 2
seconds before connecting it again.
• Make sure to place the recorder at a stable, vibration-free place during recording.
• Make sure not to connect the recorder to your computer during recording or playing.
• The system may malfunction if your computer changes to system suspend, sleep, or hibernation mode while
connecting to the recorder. Make sure to disable any changes to suspend, sleep, or hibernation mode.
• Make sure not to connect the recorder and the computer through a USB hub.
• When the recorder is connected to a computer, power (bus power) is supplied to the recorder through the
computer’s USB port. If the computer (a laptop PC, for example) is operating on battery power, this connection
may cause the computer’s battery to drain. It is thus recommended to use the computer with an AC power
adaptor.
• We do not ensure trouble-free operation on all computers that satisfy the system requirements.
22
MZ-RH1/MZ-M200.GB.2-669-084-11(1)