Hawk Industries Spinner Manual 550 HYDRAULIC Serial Numbers 1 to 205 - Manual (Page 15)

15 Operation
Operational Adjustment
1. Remove both Adjust Pins (AB)
2. Slide Drive System (DS) forward
or back to allign with the desired
pipe size adjustment holes. See
prior page(diagram) or this page
(photos) for correct adjustment
location.
3. Replace Adjust Pins (AB). New
Quick Release Pins look different
than shown on photo.
Adjust Pipe Size
AB
DS
Note
If the drive rollers are touching each
other while gripped on pipe, slip-
ping may occur. This is caused by
chain stretch (pin wear). To remedy
this problem, adjust the Spinmaster
to the next smallest setting. If this
smaller setting causes the
Spinmaster to thrust itself from the
pipe while spinning, replace the
chain. See Changing the Chain
pg.23.
950 Spinmaster 550 Spinmaster
2 7/8"
9 1/2"
8" 7" 6" 5" 4 1/2"-5" 3 1/2"-4" 2 7/8" 4 1/2"-5 1/2" 3 1/2"-4"