Martin Universal Design 92-2100 MURANO Professional Studio Easel - Manual (Page 2)

FIG 4
FIG 1
STEP 1. Assembling Base.
Take each Base Foot [ID#1] (make
sure wood hinges are on top.) along
with each Base Foot Connectors
- Make sure holes are on bottom
of base. [ID#2]. Insert T-Nut from
Carriage Bolt [ID# A] into hole in
Base Foot Connector. See FIG 1.
Repeat on all 4 sides.
For recommended assembly lay all wood parts on flat surface with all holes facing up.
Pg. 2 Created June 06 RPI
FIG 2
STEP 2. Assembling Base.
After inserting T-Nuts, continue by
inserting Carriage Bolt (6x60mm)
into the sides of the Base Foot
[ID#1] making sure bolt screws into
T-nut by aligning T-nut opening with
bolt. Repeat for each of the
remaining 3 sides. See FIG 2.
FIG 3
STEP 3. Assembling Base.
Secure each Carriage bolt by
attaching bolt with Philips
Screwdriver [ID#Y]. Use the Flat
Screwdriver [X] to hold the T-Nut in
place. See FIG 3.
2
1
2
1
1
2
Y
X
STEP 4. Assembled Base.
The Base assembly should look like
FIG 4. NOTE: Holes where T-Nuts
should be located on bottom of
assembled base, if properly
assembled.
STEP 5. Assembling Side Arms.
Start by taking the two side arms
[ID#3] and the upper side arm con-
nector [ID#4]. Position as shown in
FIG 5. Please note: The ends of the
side arms that have slots are the
bottom ends.
2
1
1
2
3
3
3
4
FIG 5
STEP 6. Assembling Side Arms.
Insert T-nut into upper arm
connector. Continue by inserting
carriage bolt 6x50mm into hole on
side of Side arm and into T-nut.
See Fig 6.
4
STEP 7. Assembling Side Arms.
Secure Carriage bolt by attaching
bolt with Philips Screwdriver [ID#Y].
Use the Flat Screwdriver [X] to hold
the T-Nut in place. Repeat with
other side. See FIG 7 & FIG 5 for
final result of this step.
FIG 6
FIG 7
STEP 8. Ratchet Center Column
Insert Ratchet Center Column up
into slotted section of upper side arm
connector. Make sure ratchet center
column is positioned as shown in
FIG 8.
FIG 8
STEP 9. Lower Side Arm Connector
Insert Ratchet Center Column down
into the oval hole on the end of the
lower side arm connector. Make sure
ratchet center column is positioned as
shown in FIG 9. T-nut Holes in
connector should be on backside.
FIG 9