Edsal 1KAC9 User Manual
Instructions : heavy duty record storage rack
Instructions : Heavy Duty Record Storage Rack,
Instructions : Heavy Duty Record Storage Rack,
Instructions : Heavy Duty Record Storage Rack,
Welded Bulk Storage Tire Rack
Welded Bulk Storage Tire Rack
Welded Bulk Storage Tire Rack
See reverse side for product parts list & contact information
General Instructions
General Instructions
General Instructions
Safety Instructions
Safety Instructions
Safety Instructions
Edsal Record Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly. The
rack units can stand individually, or for greater stability, be joined together using the common post. Individual beams
can be adjusted without disturbing the beams in adjoining units. These instructions should be followed exactly. All
parts supplied must be used as shown. Any alteration or deviation from this instruction sheet can result in unit failure.
After the unit is assembled, it must be placed on a level surface for safety, and optimal product performance.
This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product per-
formance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER !
DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf.
Use care and the proper attire when working with metal parts.
Assembly Instructions
Assembly Instructions
Assembly Instructions
Figure 4
Starter
Add-On
Figure 2
Attach the beams to the welded end frames as seen in figure 1.
Use both welded end frames to establish the left and the right sides
of the units. After a beam has been placed to the end units, tap
down with a hammer to help drive the beam end clip tabs into the
end frame post slots. To secure the beam to the end frame, insert
the plastic canoe clips through the hole in the beam bracket and
into the frame (see figure 1). NOTE: If the beam end clip tabs
become bent due to mishandling. It may be necessary to ad-
just the tabs back to their proper form.
For record storage rack, attach tie bars to the beams by inserting
them into the slots of the beams (see figure 1). NOTE : TIRE RACK
DOES NOT REQUIRE TIE BARS AND ARE NOT INCLUDED.
Particle Board Shelving can now be added to each level to com-
plete the record storage rack unit (see figure 2).
Tires can now be added to each level to complete the tire rack unit
(see figure 3).
Each end frame can be used as a common end, add on units can
be purchased to expand storage capacity (see figure 4).
Figure 1
End Frame Post
End Frame Post Slots
Canoe Clip
Beam
Tie Bar
Beam End
Clip Tabs
Figure 3