Edsal BW2472W4 User Manual

Parts, Tools required

Advertising

Instructions : BW2472W4

Bulk Storage Rack

Should you have any comments, damage, missing parts, or problems with assembly

of this unit please feel free to contact our Muscle Rack manufacturing facility at,

(773) 475-3000 and request customer service. To obtain replacement parts, please

provide the following information :

- Model # - Part # & Description - Location Purchased - Date Purchased

General Instructions

(2) - 24” x 72” Welded End Frames

(8) - 72” Beams

(8) - 24” x 36” Wire Deck Shelving

Parts

Safety Instructions

Muscle Rack Bulk Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly.
The rack units can stand individually, or for greater stability, be joined together using the common post. Individual
beams can be adjusted without disturbing the beams in adjoining units. These instructions should be followed exactly.
All parts supplied must be used as shown. Any alteration or deviation from this instruction sheet can result in unit fail-
ure. After the unit is assembled, it must be placed on a level surface for safety, and optimal product performance.

This storage rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product perform-
ance, or a possible “tipping” safety hazard. DO NOT STAND ON THE UNIT OR USE THE UNIT AS A LADDER !
DO NOT OVERLOAD ! Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf.

Use care and the proper attire when working with metal parts.

Assembly Instructions

Attach the beams to the welded end frames as seen in
figure 1. Use both welded end frames to establish the
left and the right sides of the units. After a beam has
been placed to the end units, tap the beam down at
both ends with a rubber mallet to help drive the beam
end clip tabs into the end frame post slots to secure the
beam to the end frame (see figure 1). Note: If the
beam end clip tabs become bent due to mishan-
dling. It may be necessary to adjust the tabs back
to their proper form.

The completed unit should have four (4) levels evenly
spaced for maximum stability. Note: Although the
beams are adjustable in height, it’s recommended to
evenly space them so that the stability of the unit is not
compromised.

After all beams are in place, place the wire deck shelv-
ing ( two (2) 24” x 36” pieces per level ) to each level

to complete the unit (see figure 2).

Beam

Beam End
Clip Tabs

Figure 1

End Frame Post

End Frame Post Slots

Figure 2

Wire Deck Shelving

Edsal Manufacturing Co., Inc.
Chicago, IL
Made In China

Tools Required

Rubber Mallet

Advertising