Apple Color LaserWriter 12/600 PS - Manual (Page 79)

4 Make sure the following entry is in the /etc/services file:
printer 515/tcp spooler
5 Start inetd by typing the following command at the UNIX prompt:
/etc/inetd -c
6 Repeat the steps in “Configuring HP-UX Version 9.x.”
Configuring SCO UNIX
To configure Santa Cruz Operation (SCO) version 1.2 or later of UNIX,
follow these steps:
1 Log in to the SCO machine as root .
2 Assign an IP address and IP name to the printer, as described in “Step 3: Assigning an
IP Address to the Printer,” earlier in this chapter.
3 Make sure the printer’s IP name and IP address are entered in the /etc/hosts file.
4 At the UNIX prompt, type
mkdev rlp
5 When the mkdev program asks if you want to install or remove remote line printing,
choose install even if it is already installed.
6 If remote line printing is already installed, the program will ask if you want to continue
installing the system. Answer “no” and skip to step 10.
7 If remote line printing is not already installed, the program will ask if you wish to change
the /etc/printcap file. Answer “no.”
8 The program then asks if you want to run /etc/rlpconf . Answer “no.”
9 When asked if you want to start the remote daemon, answer “yes.”
You return to the UNIX prompt.
65 Setting Up the Printer for UNIX Users