Revolabs Fusion User Guide - Manual (Page 9)

Page 9
Revolabs Solo™ Wearable Microphones turn on and mute automatically when
removed from Charger Base, to reduce noise while being attached. The
microphone has a clip on the back which allows the microphone to be easily
attached onto a shirt pocket, blouse, lapel or lanyard.
To use the Wearable Microphone:
• Remove the microphone from the Charger Base.
• Attach the microphone to clothing or to a lanyard close to the mouth,
within 6 - 12 inches (15 – 30cm) is recommended. Make sure microphone
is attached securely with the microphone port pointed up toward mouth.
• With the microphone in the wearing position, un-mute the microphone by
pressing and releasing the Mute button (confirm by viewing flashing GREEN
LED). If the volume is too low, move the microphone closer to the mouth.
• To turn microphones off, return the microphone unit to the Charger Base
or press and hold the Mute button for ~10 seconds until the LED turns
solid RED and release button.
• If the microphones are moved out of range of the Base Station (~100 feet
or 30 meters) the connection will be dropped (LED flashes all colors) and
the microphone will mute.
• After 15 seconds the microphone will beep 5 times, and will continue
beeping every 30 seconds to remind the user to return the microphone to
the conference room. If the microphone is moved back into range within
15 minutes the connection will automatically be re-established to its
original state, and the beeping will cease. If not, the microphone will turn
off.
Muting Microphones
In the default setting, each Solo microphone will mute only itself when its MUTE
button on the microphone is pressed. To mute all of the microphones, press
the red MUTE button on the Remote Control; all microphones will flash red
and no individual microphone can be unmuted until the remote MUTE button is
pressed again. All microphones will return to their prior state.
However, if the tabletop microphone master mute has been enabled (Refer to
Set-Up Guide), the mute will work as follows: in addition to the Remote
Control MUTE button muting all of the microphones, the Solo Tabletop
microphone MUTE button will also act as a master mute and mute all active
microphones. Pressing any Tabletop microphone MUTE button or the Remote
Control MUTE button will unmute all tabletop microphones. All wearable and
handheld adapter microphones in use will return to their prior state.
Revolabs Fusion™