Revolabs Single Channel Wireless Microphone System - Tandberg 6000 / 8000 MXP - Manual

Revolabs Single Channel Wireless Microphone System- Tandberg 6000 / 8000
MXP Setup Guide
N OTES AND C AUTIONS :
This setup guide will guide you through the steps needed to properly connect a Revolabs
Single Channel System to a Tandberg 6000 / 8000 MXP video codec.
1. Connecting the Cables
2. Configuring the 6000 / 8000 MXP Video Codec
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function properly.
Please read through these instructions completely before proceeding. Contact Revolabs
technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Tandberg 6000 / 8000 MXP video codec
3. QTY 1 07-STEMIC-PPP Line-to-Mic Interface Cable*
* O
PTIONAL FROM
R
EVOLABS
NOTE:
IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM
T
ANDBERG AND ARE PART OF THE
T
ANDBERG
MXP A
DMINISTRATOR
’
S
G
UIDE
© M
AY
2008