1 cleaning this machine, 1 before getting started, Cleaning this machine – Konica Minolta bizhub 4050 User Manual
Page 5: Before getting started -2, 1cleaning this machine
1.1
Before getting started
1
[Maintenance/Troubleshooting]
1-2
1
Cleaning This Machine
NOTICE
Thoroughly read all the precautions and warning labels, and be sure to follow their instructions. These labels
are provided inside the door of this machine or inside the machine.
1.1
Before getting started
Carefully handle this machine so that you can use it for an extended period of time. A failure caused by in-
correct use or rough handling is not covered by the warranty
If dust or slips of paper are left inside or outside this machine, it may reduce printing quality. We recommend
that you periodically clean this machine. Follow the guideline shown below.
-
Do not place any objects on this machine.
-
To clean this machine, use a soft cloth.
-
Do not spray detergent directly on the surface of this machine. If detergent gets into this machine
through holes, slots, etc., it may damage internal circuits.
-
Do not use abrading or corrosive agents, including solvents such as alcohol, benzene, or thinner, to
clean this machine.
-
When using detergent such as neutral detergent, try it on an obscure part of this machine to check its
effectiveness.
-
To clean this machine, do not use a sharp or textured object such as a wire, plastic cleaning pad, or
brush.
-
When you close the door of this machine, do it carefully. Do not do anything that might make this ma-
chine oscillate.
-
Do not cover this machine directly after using it. Turn the power off, then wait until this machine be-
comes cool.
-
Do not leave the door of this machine open for a long period of time. Especially, in bright light, Imaging
Unit may be damaged.
-
Do not open any door of this machine during printing.
-
Do not align sheets of paper at the top of this machine.
-
Do not grease or disassemble this machine.
-
Do not set this machine on an incline.
-
Do not touch the electric wiring, gears, or laser beam unit. Doing so may lead to a machine failure or
reduce printing quality.
-
Do not load an excessive number of sheets of paper in the output tray. Doing so may cause a paper
jam or paper curling.
-
When moving this machine, at least two people are required to do so. To prevent toner from spilling,
keep this machine horizontal when carrying it.