Konica Minolta bizhub 4050 - Manual (Page 50)

[Maintenance/Troubleshooting] 4-17
4.7 Major messages and actions 4
[Memory Full (FAX)] The fax data storage area has
become full. When sending fax data, send only
the scanned original, or manually
send it again.
When receiving fax data, print or de-
lete data saved in memory.
[Job Registration Limit Over] The number of registered jobs
has reached the upper limit. Wait until a job has been completed,
or delete a current job.
[Connection Failed] Failed to connect to the FTP
server. Check that the destination has been
registered correctly.
[Writing Error] An error has occurred while sav-
ing data onto a USB memory de-
vice. Cancel the job, then check that the
USB memory is in the write enable
state.
[Matching paper size not
available.] Paper appropriate for a print job
is not loaded in the tray. Load the appropriate paper in the
tray, then specify the correct size
and type for the loaded paper on the
Control Panel.
[Out of the Range of Auto
Zoom] The auto zoom ratio setting ex-
ceeds the allowable range. Specify the zoom ratio between 25
and 400%.
[Place Original on Glass] The original of an invalid size is
loaded on the ADF. Scan the original from the Original
Glass.
[Place Original on ADF] No original is loaded on the ADF. Load the original on the ADF.
Scan the original of different sizes
from the ADF.
[Duplex Copy Disabled] The size of the loaded paper is
not available for 2-sided copy. Cancel 2-sided copy, or change the
paper size.
[Scan TX Failed] Scan transmission has failed. After a while, cancel the job.
[Off-Hook] The handset remains picked up
after a manual transmission. Replace the handset.
[Fax TX Failed] Fax transmission has failed. This error is remedied automatically.
[Fax RX Failed] Fax receiving has failed. This error is remedied automatically.
[I-Fax TX Failed] An error occurred while sending
an Internet fax, and the job was
not ended normally. This error is remedied automatically.
[I-Fax RX Failed] An error occurred while receiving
an Internet fax, and the job was
not ended normally. This error is remedied automatically.
[E-mail forwarding failed.] An error occurred while forward-
ing the received fax by E-mail,
and the job was ended normally. This error is remedied automatically.
[PC-FAX Restricted] PC-Fax TX is prohibited. Enable PC-Fax TX.
[PC-Fax TX Error] An error occurred when PC-Fax
TX data was received on this ma-
chine. This error is remedied automatically.
[Polling RX Error] Multiple destinations have been
specified for Polling RX. Multiple destinations cannot be
specified for Polling RX. Specify only
one destination.
[Counter has reached its
maximum allowance.] The counter has reached the up-
per limit. Delete jobs.
[Job Log Error] The job log storage area on the
HDD is full. Delete job logs.
[Card Authentication Regis-
tration Error] Failed to scan the IC card at the
time of registration. This error is remedied automatically.
[USB Connection Error] The same type of USB device is
connected. Disconnect the USB device.
Message Description Remedy