Pioneer KRP-600A - Manual (Page 106)

Additional information 15
106
En
If the following error codes appear on the screen, check the corresponding items in the table.
Signal names for 15-pin mini D-sub connecter
OTHER
• Power ON indicator or STANDBY
indicator is quickly flashing. • Internal protective circuits may have been activated. For the display, first turn Power On ( a) off,
wait one minute or more, then switch the power on again by turning Power On ( a) on. If the
indicator is still flashing, unplug the display’s power cord from the power outlet. Wait one to two
minutes then plug in the display again. For the Media Receiver, unplug the Media Receiver’s
power cord from the power outlet. Wait one to two minutes then plug in the Media Receiver again.
If this does not solve the problem, contact a Pioneer Service Center. These are listed on your
warranty card for each country. Alternatively, check the Pioneer Web site (see back cover) for
contact details.
Code Message Check
SD04 and SD11 Powering off. Internal temperature is too high.
Check temperature around the display. Check if the ambient temperature of the display is high.
SD05 Internal protection circuits turning power OFF.
Possible short in the speaker cable. Check the speaker cable connections between the display and
the speakers.
SD11 Powering off. Internal temperature is too high.
Check temperature around media receiver. Check if the ambient temperature of the Media Receiver is
high.
Problem Possible solution
Pin No. Signal name Pin No. Signal name
1 R 9 +5 V
2 G 10 GND (ground)
3 B 11 Not connected
4 Not connected 12 SDA
5 Not connected 13 HD
6 GND (ground) 14 VD
7 GND (ground) 15 SCL
8 GND (ground)
KRP-600A_500A.book Page 106 Monday, September 8, 2008 10:31 AM