Brocade Communications Systems Brocade ICX 6650 - Manual (Page 21)

Brocade ICX 6650 Administration Guide 3
53-1002600-01
Logging on through the CLI
1
To display management port statistics, enter the show statistics management command.
Brocade(config)#show statistics management 1
Port Link State Dupl Speed Trunk Tag Pri MAC Name
mgmt1 Up None Full 1G None No 0 748e.f80c.5f40
Port mgmt1 Counters:
InOctets3210941OutOctets1540
InPkts39939OutPackets22
InBroadcastPkts4355OutbroadcastPkts0
InMultiastPkts35214OutMulticastPkts6
InUnicastPkts370OutUnicastPkts16
InBadPkts0
InFragments0
InDiscards0OutErrors0
CRC 0 Collisions0
InErrors0 LateCollisions0
InGiantPkts0
InShortPkts0
InJabber0
InFlowCtrlPkts0OutFlowCtrlPkts0
InBitsPerSec83728OutBitsPerSec24
InPktsPerSec130OutPktsPerSec0
InUtilization0.01%OutUtilization0.00%
Syntax: show statistics management <num>
To display the management interface statistics in brief form, enter the show statistics brief
management command.
Brocade(config)#show statistics brief management 1
PortIn PacketsOut PacketsTrunkIn ErrorsOut Errors
mgmt1399462200
Total399452200
Syntax: show statistics brief management <num>
Logging on through the CLI
Once an IP address is assigned to a Brocade device running Layer 2 software or to an interface on
the Brocade device running Layer 3 software, you can access the CLI either through the direct
serial connection to the device or through a local or remote Telnet session.
You can initiate a local Telnet or SNMP connection by attaching a cable to a port and specifying the
assigned management station IP address.
The commands in the CLI are organized into the following levels:
• User EXEC – Lets you display information and perform basic tasks such as pings and
traceroutes.
• Privileged EXEC – Lets you use the same commands as those at the User EXEC level plus
configuration commands that do not require saving the changes to the system-config file.