Britax ROUND ABOUT 50 - Manual (Page 40)

38
Child Seat Functions
Adjusting Harness Buckle Position
This child seat allows the buckle to be adjusted to one
of three positions based on the weight of the child.
Properly adjusting the buckle increases comfort and
safety.
IMPORTANT:
• This child seat is shipped with the buckle in position
1 (Fig. A). Use buckle position 1, 2, or 3 that is closest
to but not underneath your child. Do not use buckle
position 3 in rear-facing mode.
• In rear-facing installations, the LATCH strap or vehicle
belt must rest IN FRONT OF the child seat buckle
when using buckle slots 1 or 2 (Fig. A). If the LATCH
strap is not in this position, pull the LATCH strap and
connectors from behind the buckle strap and re-
thread accordingly.
1 Recline the child seat.
2 Locate the metal buckle strap retainer on bottom of the child seat.
3 Pull retainer away from child seat to loosen.
4 Turn the retainer so the short side will go through the slot in the child
seat shell (Fig. B).
5 Push the retainer through slots in the shell and cover to the top of
the child seat.
6 Locate slot in cover and shell for desired harness buckle location.
7 Push the buckle retainer so the short side will go through the slot in the
cover and child seat shell.
8 Pull harness buckle away from child seat until tight then verify the
strap is not twisted and the release button is facing out.
A
b
WARNING! This child seat should not be used forward-
facing for children less than one year of age and weighing less
than 20 lbs (9.1 kgs).