J.P. Instruments Fuel Scan 450M Pilots Guide User Manual
Page 14
Page 12
FS-450M Fuel Scan
(o(L)
)
New K Factor (R )= (n(R)
)
x (p(R) )
(o
(R)
)
Every time you fine tune the K factors, record the measurements here:
Date
n
FS-
450M fuel
used
o
actual
fuel used
p
Current K
factor
Left Right
New K factor
=
n
x
p
/
o
Left Right
If you haven’t already done so, start the pilot programming
procedure, simultaneously hold the STEP and AUTO buttons for
five seconds. You will see the words
for two seconds.
1. Tap STEP button twice to advance to the display
2. Hold STEP and AUTO buttons simultaneously for five seconds.
3. Press STEP button. First digit blinks:
2
9.00
4. Tap or Hold the AUTO button to change flashing digit:
I
9.00
5. Tap STEP button for next digit: I
9
.00
6. Tap or Hold the AUTO button to change flashing digit: I
8
.00
7. Tap STEP button for next digit: I8.
0
0
8. Repeat items 6 and 7 for the remaining digit.
9. To exit, hold STEP and AUTO buttons simultaneously for five
seconds.
10. See
11. Repeat steps 1 through 8 for the right engine K factor.