Apple Power Macintosh 7300 series - PC Compatibility Card - Manual (Page 128)

Installing memory on the card involves the following steps:
m removing the card
m installing the new DIMM
m reinstalling the card
Removing the card
1 Open the computer.
IMPORTANT For detailed instructions on opening your Power Macintosh 7300
computer, including important precautions, see Appendix B. To learn how to
open your Power Macintosh 4400 computer, see the
PC Compatibility Card
Update that came with your computer.
2 Remove any cables from the PC Compatibility Card ports.
If you have not already done so, remove the loopback cable, and the PC game
controller cable (if one is attached), from the ports on the back of the PC
Compatibility Card.
3 If necessary, disconnect the audio cables from the PC Compatibility Card.
Because the audio cables can be difficult to remove, it’s best to leave them
connected if possible. If you feel you can pull the card out and access the
DIMM slot without disconnecting the audio cables, leave the cables in place.
WARNING Your PC Compatibility Card contains one socket for
additional video RAM. To avoid damage to your computer, Apple
recommends that you have your Apple-authorized dealer install
additional video RAM (for a fee). If you attempt to install additional
video RAM yourself, any damage you may cause to your equipment will
not be covered by the limited warranty on your computer. See an
Apple-authorized dealer or service provider for additional information
about this or any other warranty question.
128 Appendix C