I30 ks a, Safe, Ok i30 i – IKA KS 130 control User Manual
Page 23
Settingthe operation mode (control model only)
The Control device model can be operated in the modes descri-
bed below:
Operation mode A:
The KS 130 control is switched into operating mode A when it
leaves the factory. After the device is turned on with the power
switch (flip switch), the agitation and time expiration functions
are turned off. The set target values are stored and are display-
ed digitally. They are adopted when the corresponding functions
are turned on. the set target values can be varied. After the
power has been turned off and back on, both functions must be
started again. The upper speed limit can only be set or changed
in operating mode A. You can recognice operating mode A by
the factthat no star is displayed in the menu bar display of the
time setting.
After the power has been interrupted, the device will no longer
automatically start up in operating mode A by itself any more.
After you have selected the operating mode and turned on the
device, the following process will be shown on the display.
a.) All display elements in the digital displays are activated for
about 2 seconds.
b.) The device type (left display) and operating mode (right dis-
play) are displayed for about 2 seconds.
c.) After this, the set (ore stored) upper speed limit of the agita-
tor is shown in the left display with SAFE, the unit of measure
rpm and flashing SV for about 2 seconds. As long as the dis-
play is flashing with SV , it is possible to change the upper
speed limit by pressing the turn button and turning at the same
time.
d.) If the upper speed limit is fixed, the unit 1/min in the left dis-
play changes to OK. The new time target value that is set or sto-
red in the right display (for example 3:58) is displayed with an
indication of h min and a flashing SV .
e.) The new speed target value that has been set or stored in the
left display (for example 130) is then shown with the unit 1/min
and flashing SV .
f.) By pressing the left or the right turn button, you can place the
agitator in operation with the stored value or the one that has
just been set. The actual speed and time values are then shown
in large format on the display. The actual value of the time set-
ting must be understood from this point onward as the time
remaining for the agitation process. If zhe remaining has reached
zero, the agitator stops its motion.
23
032007
Operating modes
I30
KS
A
230
SAFE
SV
I
min
/
A
230
SAFE
min
n
i
358
:
SV
SV
OK
I30
I
min
/
SV
min
n
i
358
:
SV