JLG G6-42A Service Manual - Manual (Page 226)

Electrical System
9-62 G6-42A, G9-43A, G10-43A
9.16 JOYSTICK FAULT CODES
(G9-43A/G10-43A S/N 0160040675 AND AFTER INCLUDING 0160040468 & 016040672)
DTC Event Comment Latched
211 Power Cycle • No motion restrictions
• This Help Message is issued at each power-up.
This serves to indicate which messages have been
recorded in Logged Help since the last power-up
event.
No
2127 Aux Joystick Not In Neutral
Position At Power Up
• Auxiliary Hydraulic A & B prevented
• The auxiliary hydraulic joystick must be in the
neutral position (established by Calibration) when
the control system is energized or it is ignored until
is momentarily returns to neutral.
• Active when AUX HYDRAULIC is ENABLED
No
2123 Joystick Trigger Switch
Active At Power Up
• De-Clutch functionality prevented (transmission
always engaged)
• The trigger for de-clutch should be open (released)
when the control system is energized or is ignored
until it momentarily opens.
No
2125 Joystick Roller Not In The
Neutral Position At Power
Up
• Fork Tilt Up & Down prevented
• The left roller must be in the neutral position
(established by Calibration) when the control
system is energized or it is ignored until is
momentarily returns to neutral.
No
2356 Auxiliary Hydraulic Joystick -
Neutral Disagreement • Auxiliary Hydraulic A & B prevented
• The auxiliary joystick’s neutral switch was open
while the analog voltage was in the active range,
or the neutral switch was closed while the analog
voltage was in the neutral range. Auxiliary
hydraulics will be prevented until the next power
cycle. This fault may be caused by improper
joystick calibration, improper wiring, a joystick
issue or a control module issue.
• Neutral switch must be open for 0%; closed
beyond ±25%
Yes
2357 Auxiliary Hydraulic Joystick -
Out Of Range High
• Auxiliary Hydraulic A & B prevented
• The auxiliary joystick analog voltage was
measured to be greater than 4.85V. Auxiliary
hydraulics will be prevented until the next power
cycle. This fault may be caused by improper
wiring, a joystick issue or a control module issue.
• Active when Machine Setup’s AUX HYDRAULIC is
set to ENABLED
Yes