JLG G6-42A Service Manual - Manual (Page 82)

Cab and Covers
4-8 G6-42A,G9-43A, G10-43A
4. Disconnect the electrical harness connector (8).
5. Remove the bolts (9) securing the throttle pedal to
the throttle pedal bracket (10).
6. Remove the throttle pedal assembly from the cab.
b. Throttle Pedal Installation
1. Position the throttle pedal in its mounting location
within the cab.
2. Secure the throttle pedal into position with the pivot
pin.
3. Install the throttle pedal ball joint to the throttle pedal.
4. Properly connect the battery.
5. Verify proper throttle pedal operation.
6. Close and secure the engine cover.
7. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
4.3.4 Boom Joystick Assembly
a. Joystick Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake and turn the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel.
3. Properly disconnect the battery.
4. Lift the joystick’s rubber sleeve (11), remove the
bolts securing the boom joystick to the cab.
5. Lift the joystick from its mounting position.
6. Label, disconnect and cap the hydraulic hoses
attached to the boom joystick.
7. Disconnect the electrical connectors.
8. Remove the joystick.
b. Joystick Installation
1. Uncap and connect the previously labeled hydraulic
hoses to their appropriate locations.
2. Connect the electrical connectors.
3. Install the bolts securing the joystick to the cab.
4. Properly connect the battery.
5. Test the joystick functions:
a. Move the joystick handle rearward, activating the
boom lift function. The boom should RISE.
b. Move the joystick handle forward, activating the
boom lower function. The boom should LOWER.
c. Move the joystick handle to the right, activating
the boom extend function. The boom should
EXTEND.
d. Move the joystick handle to the left, activating the
boom retract function. The boom should
RETRACT.
MAL1000
8
9
10
MY6480
11 11
(If Equipped) (If Equipped)
MY6480
13
12
(If Equipped) (If Equipped)
14