JLG 600A_AJ Service Manual - Manual (Page 91)

SECTION 3 - CHASSIS & TURNTABLE
3121201 – JLG Lift – 3-41
enough to expose the retaining ring groove. Wind
the spiral retaining ring (7) into the groove in the cyl-
inder block.
4. Turn the block over and install the retaining ring (8),
hold-down pins (9), and ball guide (10) to the cylin-
der block.
5. Install the pistons (11) to the slipper retainer (12).
Install the piston/retainer assembly into the cylinder
block. Ensure the concave surface of the retainer
seats on the ball guide. If you're reusing the pistons,
install them to the original block bores. Lubricate the
pistons, slippers, retainer, and ball guide before
assembly. Set the cylinder kit aside on a clean sur-
face until needed.
6. Install the journal bearings (13) into the housing
seats. Use assembly grease to keep the bearings
seated during assembly. Ensure the locating nubs
drop into the cavities in the seats. If you're reusing
the bearings, install them in the original location and
orientation. Lubricate the journal bearings.
7. Install the swashplate (14) into the housing. Tilt the
swashplate and guide the servo lever ball into its
socket in the servo piston rod. Ensure the swash-
plate seats into the journal bearings and moves
freely. Lubricate the running surface of the swash-
plate.
7
6
5
4
8
9
10
12
11
4. Block Spring Washer
5. Block Spring
6. Outer Washer
7. Spiral Retaining Ring
8. Retaining Ring 9. Holddown Pins
10. Ball Guide
11. Piston
12. Slipper Retainer
Figure 3-31. Cylinder Kit Assembly
14
13
13
13. Journal Bearings
14. Swash Plate
Figure 3-32. Swash Plate and Journal Bearing