JLG 15/20MSP Operator Manual - Manual (Page 22)

SECTION 2 - PREPARATION AND INSPECTION
2-4 – JLG Lift – 3121230
2.3 PRE-START INSPECTION
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage (oil, fuel,
or battery fluid) or foreign objects. Report any leakage to
the proper maintenance personnel.
2. Decals and Placards – Check all for cleanliness and
legibility. Make sure no decals or placards are missing.
Make sure all illegible decals and placards are cleaned
or replaced. (Reference "Decal Installations" in Section
3).
3. Operators and Safety Manuals – Make sure a copy of
the Operator and Safety Manual, EMI Safety Manual
(Domestic only), and ANSI Manual of Responsibilities
(Domestic only) is enclosed in the weather resistant
storage container.
4. Daily Walk-Around Inspection – (See Section 2.4)
5. Battery – Charge as required.
6. Hydraulic Oil – Check the hydraulic oil level.
NOTE: Check Service Manual for instructions and hydraulic oil
specification before adding. DO NOT OVERFILL.
7. Function Check – Check all machine controls for oper-
ation per Section 2.5, Function Check.
If optional equipment is installed on this machine refer to Section 3
for specific Pre-Start Inspection and Operation instructions.
FILL TO LINE
on Hydraulic
Reservoir
indicates the
proper level for
hydraulic oil.