JLG X20JP - X600AJ Service Manual - Manual (Page 229)

SECTION 6 - JLG CONTROL SYSTEM
3121623 – JLG Lift – 6-13
CAN-BUS DIAGNOSTICS
DISPLAYED ICONS
If an icon of the followings appears on the display check
as indicated here below.
6.3.1
THIS IS NOT A CAN-BUS ERROR
Control error menu: check from the display into the ERROR MENU push-
ing 6 – MENU and then 3 – ERRORS, then skipping the pages it will be
showed the devices error status, where there’s a NO means that the sig-
nal from two lines of that device are not according each other, so check it
and check its connections
Electronic board or software wrong: check if the platform’s devices are
compatibles with installed software, if necessary contact Hinowa with the
serial number and the release number of the installed software
CAN BUS signal missing: check the connection as indicated at the step 4
of the present procedure
2° cylinder sensor missing: check the connector of the position sensor on
3° arm cylinder and the sensor itself check also the battery charge level, in
case of low battery level let the engine run for some minutes, then check if
this alarm disappear.
Battery low charge alarm: it could appear especially after the engine start,
check the charge level and eventually recharge.