JLG X550AJ Operator Manual - Manual (Page 24)

SECTION 2 - PREPARATION AND INSPECTION
2-4 – JLG Lift – 3128791
Pre-Start Inspection
The Pre-Start Inspection should include each of the fol-
lowing:
1. Cleanliness – Check all surfaces for leakage (oil,
fuel, or battery fluid) or foreign objects. Report any
leakage to the proper maintenance personnel.
2. Structure - Inspect the machine structure for dents,
damage, weld or parent metal cracks or other dis-
crepancies.
3. Decals and Placards – Check all for cleanliness
and legibility. Make sure none of the decals and
placards are missing. Make sure all illegible decals
and placards are cleaned or replaced.
4. Operation and Safety Manuals – Make sure a copy
of the Operation and Safety Manual, AEM Safety
Manual (ANSI markets only), and ANSI Manual of
Responsibilities (ANSI markets only) is enclosed in
the weather resistant storage container.
5. Walk-Around Inspection – Refer to Figure 2-2.
6. Battery – Charge as required.
7. Fuel (Combustion Engine Powered Machines) – Add
the proper fuel as necessary.
8. Engine Oil Supply (Combustion Engine Powered
Machines) - Ensure the engine oil level is at the Full
mark on the dipstick and the filler cap is secure.
9. Hydraulic Oil – Check the hydraulic oil level. Ensure
hydraulic oil is added as required.
10. Accessories/Attachments - Reference the Opera-
tion and Safety Manual of each attachment or acces-
sory installed upon the machine for specific
inspection, operation, and maintenance instructions.
11. Function Check – Once the “Walk-Around” Inspec-
tion is complete, perform a functional check of all
systems in an area free of overhead and ground
level obstructions. Refer to Section 4 for more spe-
cific operating instructions.
IF THE MACHINE DOES NOT OPERATE PROPERLY, TURN OFF THE
MACHINE IMMEDIATELY! REPORT THE PROBLEM TO THE PROPER
MAINTENANCE PERSONNEL. DO NOT OPERATE THE MACHINE
UNTIL IT IS DECLARED SAFE FOR OPERATION.
Parent Metal Crack Weld Crack